The N2060Apro differential probe provides a safe instrument for all oscilloscopes, it can convert from a high input differential voltage to a low voltage (≤7V), and display the waveform on the oscilloscope with a bandwidth of up to 200MHz, which is ideal for high-power testing, R&D, and maintenance use. The differential probe output indication is designed to attenuate the relative amount of input impedance at 1MΩ when operating the oscilloscope, and is exactly 2 times the amount when using a 50Ω matcher.

Power/Ratio Button:

Press once to turn on the power; Press and do not move for two seconds to indicate power off;

Power/Ratio Indicator:

Short press the power button, the light lights up red for the ratio of 1000x, yellow for the ratio of 100x;

Frequency limit/zero button:

Short press the frequency limit, the frequency limit/over-range indicator light will light yellow; If it is overloaded, the frequency limit/overrange indicator light will light red; Press and hold until the power indicator flashes to zero.

Operating Procedures:

The output BNC interface of the differential probe is connected to the oscilloscope.

Adjust the vertical switch on the oscilloscope if necessary.

Adjust the attenuation rate and vertical switch on the oscilloscope to a consistent position.

Note: The power must be turned on.

The actual vertical bias is equal to the attenuation multiplied by the vertical bias selected on the oscilloscope, e.g. twice the 50Ω load used.